The method of removing the raw material belt on the water pipe, the raw material belt used in the case of bad sealing, water leakage, or the process that needs to be replaced for a longer period of use, then in this case, for the water pipe used by the raw material strip products, its application how to remove it, in order to make you have a certain understanding, raw material belt manufacturers simply for you to share. Then first of all, when we are dealing with, then it will be removed after the joint in the residual glue need to use a wire brush to clean up, in order to prevent leakage. Then there is the installation of about 3 minutes after the tightening and adjust the angle, or affect its curing effect. The service life of the raw material belt can reach 50 years, but its advantages are not in the material cost, the material cost is high, the use of liquid raw material belt will not affect the quality of tap water, the installation of four hours after the pressure test, the construction environment is clean, does not contain harmful substances, greatly reducing the intensity of labor, leakage rate of 10% . The material cost is much cheaper than the raw material belt, which saves a lot of manpower, reduces the overall cost and improves the work efficiency. You can reapply glue, brush the glue evenly, but wash your hands immediately after the job is done. For traditional raw meal strips, use a steel brush to remove the residue.